CONTROLS
- Siemens PLC S7-200 Std or (A.B. plc IN OPTION)*
- 24V control system
- Current overload protection (fuses)
- Siemens monochrome touch panel
- On stand Nema 4 rated control cabinet
- Autoheight sensing photoeye with on/off selection
- Power on/off lockable switch and indicator light
- Strart/Stop and Reset button
- One panel mount emergency stop station
- Manual function for table fwd/rev.,
- Manual carriage up/down,
- * All Conveyor Frw/Rev
- Variable 12 RPM
- Single carriage speed
- Separate top and bottom wrap on screen selection
- Positive turntable home position braking system
- Film force to load control
- Film force release for easy pull at start and
end of cycle
- Sensing device for film out/broken with visual
alarm
- On screen intuitive alarm diagnostic
- Air pressure switch*
- Double brush dust tight slip ring
- Manual clamp jog
- Non Proprietary part
- c CSA us approved
- * Bypass mode selector switch option
- On screen wrapping performance analysis
- On screen maintenance program and instruction
FILM DELIVERY SYSTEM
- 20" Econo NO-THREAD® Powered Pre-Stretch
- 1/2 HP AC motor with VFD , Chain & sproket
driven
- 50-300% prestretch ratio (preset to customer
spec, Std 200%)
- Electronic film tension control with linear
device
- Safety door with Lexan roller cover
FILM CARRIAGE DRIVE
- 1/2 HP AC motor with variable frequency drive
- Two ANSI #40 chain carriage lifts for safety
- Dual ½" CRS ways with UHMW-PE carriage
glides
FILM TAIL TREATMENT
- Automatic film clamping
- Pulsed controlled cutter
- Film alignment arm
- Brush-on film tail treatment, Heat Seal available
*
TURNTABLE
- Max. 12 RPM variable speed
- 1 HP AC motor with variable frequency drive
- Heavy duty 25" Ring Gear Bearing drive
- * Automated lube station option for ring gear
bearing
- Electronic soft start/stop
- Positive turntable alignment controlled by proximity
sensor
- Electric brake
TURNTABLE CONVEYOR
- 76" dia. 1/2" steel plate
- 2-1/2" dia. rollers on 3-3/4" centers
- 1/8" wall cold rolled electric welded steel
rollers
- All full length rollers driven
- 52" BFR (between frame rails)
- 3/4 HP AC motor with contactor
- #40 ANSI chain drive
- Heavy duty cast iron flange mounted bearing
CONVEYOR
- 5' in / 5' out powered contoured conveyor with
smooth transfer
- Standard: Pass height 18", other pass heights
available *
- 1/8" wall cold rolled electric welded steel
rollers
- 2-1/2" dia. rollers on 3-3/4" centers
- 52" BFR (between frame rails)
- All full length rollers driven
- 3/4 HP AC motor with contactor
- * All forward reverse manual mode
- Heavy duty structural steel design
- Heavy duty cast iron flange mounted bearings
- Fix 30 FPM conveyor speed
- Additional conveyors and other types available
upon request. *
STRUCTURE
- Formed steel tower (14 gauge)
- Forklift Portable base design (from both ends)
- Heavy duty structural steel construction
- Lag bolt brackets to secure machine to the floor
TECHNICAL INFORMATION
- The machine is provided with a manual including
electro/mechanical
schematics and drawings
- Trouble shooting guide
- Installation instructions
WARRANTY
- All Wulftec-automatic machines come with a three
year warranty.
25" ring gear bearings are warranted for
ten years.
- All Wulftec prestretch rubber rollers have a
3 years warranty.
Optional *
|
